GrainQuotaGrain capacity from your hardness and your household, not from a box label.

2 grains per gallon: what it means for a household of 4

2 grains per gallon, 4 people
34ppm as CaCO₃
slightly hard — about 31 lb of dissolved mineral passes through the plumbing each year
2 grains per gallon, 4 people31 lbMineral through t…600 grainsGrains removed pe…
The same number in ppm2 gpg × 17.134mg/L
Classificationnoticeable on glassware, rarely worth softeningslightly hard
Mineral through the pipes per year300 gal/day at 34 mg/L31lb
Grains removed per day2 gpg × 300 gallons600grains
Days between regenerations, 32,000-grain unitabout 24,000 usable grains at an efficient salt setting40
Salt used per yearabout 3,500 grains removed per pound of salt63lb

Notes

  • Two units, one number, and everyone mixes them up. 2 gpg is 34 ppm — multiply by 17.1 to go one way, divide to go back. Water utilities usually report ppm, softener manuals want gpg, and a softener set on the wrong one is out by a factor of seventeen.
  • 31 pounds of dissolved mineral a year is the number worth holding on to. That is calcium and magnesium carbonate passing through the plumbing of a 4-person house at this hardness. Most of it leaves with the water; the fraction that does not is what coats the heating element, narrows the pipe and dulls the shower glass.
  • Where it lands first is the water heater. Scale settles on the bottom of a gas tank between the flame and the water, so the burner has to work through an insulating layer, and on the elements of an electric tank until they overheat and fail. Flushing a few gallons off the drain valve once a year is the cheapest maintenance in the house and almost nobody does it.
  • At this hardness a softener is a solution looking for a problem. Below about 3.5 gpg there is little to remove, and softened water at this level adds sodium and a slippery feel for no real gain. Spend the money on a test for what is actually in the water instead.
  • Iron changes the sum, and it is not on most reports. Every 1 ppm of dissolved iron adds roughly 4 gpg of load to a softener, so 3 ppm of iron on 2 gpg water behaves like 14 gpg. Above about 3 ppm — or at any level once the pH is over 7 — a softener is the wrong tool entirely and needs a filter ahead of it.
  • Test strips give you one number badly. A lab test costs little and returns hardness, iron, manganese, pH and total dissolved solids together. Those five decide the equipment; the strip decides nothing.

2 gpg is 34 ppm, and that is slightly hard

The two units are the same measurement wearing different clothes. One grain per gallon equals 17.1 milligrams per litre of calcium carbonate. Utilities report ppm; softener manuals want gpg; a unit programmed with the wrong one is out by a factor of seventeen.

31 pounds of mineral a year

That is what passes through the plumbing of a 4-person household at this hardness — pure arithmetic from 34 mg/L and the water actually used. Most of it leaves with the water. The fraction that does not is what coats the element, narrows the pipe and frosts the shower glass.

Where it lands first

The water heater. In a gas tank scale settles between the flame and the water, so the burner works through an insulating blanket; in an electric tank it builds on the elements until they overheat. Draining a few gallons off the valve at the bottom once a year is the cheapest maintenance in the house, and almost nobody does it.

What to test before buying anything

Hardness, iron, manganese, pH and total dissolved solids — one lab test, five numbers. Iron matters more than people expect: each 1 ppm adds roughly 4 gpg of load to a softener, and above pH 7 a softener cannot hold it at all.

Nearby sizes

Read more